 |
 |
 |
|
|
|
[Sponsors] | ||||
October 22, 2007, 03:11
|
postprocessing keeps hanging
|
#1 |
|
Guest
Posts: n/a
|
Hi. I was wondering if I can adjust some settings in Fluent to speed up its post-processing. Cuz I have a grid of about 1 million cells and fluent really takes a very long time to display a contour plot.
Thanking you in advance |
|
|
||
|
October 22, 2007, 09:16
|
Re: postprocessing keeps hanging
|
#2 |
|
Guest
Posts: n/a
|
Assuming this is a steady state solution, for 1 million cells, a contour plot should be relatively fast (usually within 0-20 seconds to produce). If not, are you exceeding memory allocations for your computer?
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| using fieldAverage library to average postprocessing | eelcovv | OpenFOAM Programming & Development | 32 | May 17, 2022 09:55 |
| How to export the specific heat and viscosity for postprocessing (compressible) ? | david39 | OpenFOAM Post-Processing | 2 | January 4, 2019 07:04 |
| Postprocessing in 3d - Creating part of a surface | shankara.2 | FLUENT | 0 | July 13, 2009 17:33 |
| Question about Postprocessing Using UDF(in tutoria | sarah_ron2002 | FLUENT | 1 | April 10, 2007 16:17 |
| hanging node | Ludovit | FLUENT | 0 | March 26, 2003 12:42 |
Linear Mode
