Setting up a simulation for a compression corner -- CFD Online Discussion Forums

November 6, 2007, 10:49	Setting up a simulation for a compression corner	#1
Serene Guest Posts: n/a	Hi, I am facing a lot of problems trying to run a simulation for a compression corner. I am trying to simplify my approach right now, and is assuming an inviscid and compressible flow. I use the density-based solver, and i believe that i should use set my inlet as a pressure inlet. however, setting my inlet to pressure inlet makes it difficult for me to define my mach number at the inlet boundary. how can i make sure i get a mach number of say, 2,at the inlet boundary?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3D centrifugal compressor simulation	nuimlabib	Main CFD Forum	0	April 2, 2010 22:08
Setting up Flow around a Wing Simulation help	Atella	CFX	3	January 3, 2010 11:51
Replacing mesh while running a simulation	akultane	CFX	1	November 15, 2009 13:46
transient simulation: natural convection problem?	Basics	CFX	3	September 25, 2002 09:42
3-D Contaminant Dispersal Simulation	Apple L S Chan	Main CFD Forum	1	December 23, 1998 10:06

All times are GMT -4. The time now is 02:40.