|
[Sponsors] |
November 5, 2007, 10:19 |
Transient boundary conditions
|
#1 |
Guest
Posts: n/a
|
Hello everybody,
I'm using fluent 6.2.16 and i have to simulate the inlet manifold of an engine. I'd like to set transient boundary of pressure at the outlet but I understand nothing to the fluent help. Can someone help me? |
|
November 5, 2007, 15:02 |
Re: Transient boundary conditions
|
#2 |
Guest
Posts: n/a
|
Do you mean your B.C at the outle varying with the Time? If it's tru I guss you have to write a UDF to set your B.C correctly.
|
|
November 5, 2007, 15:03 |
Re: Transient boundary conditions
|
#3 |
Guest
Posts: n/a
|
Do you mean your B.C at the outle varying with the Time? If it's true I guess you have to write a UDF to set your B.C correctly.
|
|
November 5, 2007, 16:07 |
Re: Transient boundary conditions
|
#4 |
Guest
Posts: n/a
|
yes, they are varying with the time. I heard about UDF, but I don't know how to do. Where can I find some examples?
|
|
November 6, 2007, 05:08 |
Re: Transient boundary conditions
|
#5 |
Guest
Posts: n/a
|
What I need to do is to vary from a wall type condition to a pressure outlet type condition during a time and I don't know what to write in the UDF...
|
|
November 6, 2007, 07:28 |
Re: Transient boundary conditions
|
#6 |
Guest
Posts: n/a
|
Yau can actually write it within UDFs and you need to write a simple DEFINE_PROFILE macro. You can also fine some example through UDF manual.
|
|
November 6, 2007, 07:47 |
Re: Transient boundary conditions
|
#7 |
Guest
Posts: n/a
|
Ok, Thank you. I'll try to do this...
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 13:06 |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Help with boundary conditions | Dan | CFX | 0 | April 3, 2006 11:32 |
Transient periodic analysis & Boundary conditions | Michele | FLUENT | 0 | March 25, 2006 16:07 |