|
[Sponsors] |
Setting up a simulation for a compression corner |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 6, 2007, 10:49 |
Setting up a simulation for a compression corner
|
#1 |
Guest
Posts: n/a
|
Hi,
I am facing a lot of problems trying to run a simulation for a compression corner. I am trying to simplify my approach right now, and is assuming an inviscid and compressible flow. I use the density-based solver, and i believe that i should use set my inlet as a pressure inlet. however, setting my inlet to pressure inlet makes it difficult for me to define my mach number at the inlet boundary. how can i make sure i get a mach number of say, 2,at the inlet boundary? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D centrifugal compressor simulation | nuimlabib | Main CFD Forum | 0 | April 2, 2010 22:08 |
Setting up Flow around a Wing Simulation help | Atella | CFX | 3 | January 3, 2010 11:51 |
Replacing mesh while running a simulation | akultane | CFX | 1 | November 15, 2009 13:46 |
transient simulation: natural convection problem? | Basics | CFX | 3 | September 25, 2002 09:42 |
3-D Contaminant Dispersal Simulation | Apple L S Chan | Main CFD Forum | 1 | December 23, 1998 10:06 |