|
[Sponsors] |
November 4, 2007, 06:44 |
urgent need help with wall adhesion angle
|
#1 |
Guest
Posts: n/a
|
can anyone tell me how much the value of contact angel for (water-air) flow over each other must I set at wall boundary?
cheers kb |
|
November 6, 2007, 02:03 |
Re: urgent need help with wall adhesion angle
|
#2 |
Guest
Posts: n/a
|
Is there anybody can answer me this question I not think it too difficult? who can answer me please?
kb |
|
November 7, 2007, 15:28 |
Re: urgent need help with wall adhesion angle
|
#3 |
Guest
Posts: n/a
|
HI: It depends on your surface material. The contact angle can vary a lot. It is surprisingly difficult to find a good reference with contact angle data for different surfaces. For example, on steel you might use 75deg, but on typical quartz you would use maybe 30deg. Note also that what you enter into Fluent depends on which phase you defined as the primary phase (see user guide).
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Thin Wall Heat Transfer BC for rhoSimpleFoam | swahono | OpenFOAM Running, Solving & CFD | 12 | October 4, 2013 12:49 |
how to specify wall contact angle for compressibleInterFoam? | phsieh2005 | OpenFOAM Running, Solving & CFD | 4 | December 18, 2012 16:01 |
UDF for wall slipping | HFLUENT | Fluent UDF and Scheme Programming | 0 | April 27, 2011 13:03 |
Plotting particle wall impact angle (Lagrangian pt | Bart Prast | CFX | 0 | January 26, 2009 05:23 |
Wall functions | Abhijit Tilak | Main CFD Forum | 6 | February 5, 1999 02:16 |