reversed flow
hi, i am studing about impinging air jet. i have a 2D model. but, fluent gives me "reversed flow" warning for all iteration. i have tried so many mesh structures, I extended my geometry but I couldnt solve this problem. What would you suggest to eliminate this problem?
|
Re: reversed flow
Try initialising using a small velocity then steadily increase it to the desired value through out the solution.
|
Re: reversed flow *NM*
|
Re: reversed flow
i have tried initialising using small velocity. reversed flow error disappeared. but after about 500 iteration it appeared again and reserved flow faces increased steadily.
|
Re: reversed flow
Merhaba MUstafa sanırım benim 2 sene önce yaptığım tez ile aynı konu üstünde çalışıyorsun bende MÄ°nogowa nın impinging jet testini fluentte uygulamaya çalışmıştım matlabdede çıkan sonucları karşılaÅŸtırmıştım ÅŸuan iÅŸteyim ama müsait olursam bu konuda sana yardımcı olmaya çalışırım.
|
Re: reversed flow
çok , sevinirim. çünkü denemediÄŸim bir durum kalmadı diye düÅŸünüyorum. kitlenmiÅŸ durumdayım. yardımlarınızı bekliyorum...
|
Re: reversed flow
Hi Mustafa and emre,
Could be interesting for somebody in the CFD community to understand your responses. Sorry but I can not understand you if you do not post messages in english. Thank you in advance. |
All times are GMT -4. The time now is 16:45. |