 |
 |
 |
|
|
|
[Sponsors] | ||||
November 25, 2007, 22:44
|
Drag coefficient - frontal area
|
#1 |
|
Guest
Posts: n/a
|
Hi,
I am doing the simulation of flow over the half portion of the truck using symmetry boundary condition for side plane. In reference value panel, which area should be used? either full truck frontal area or half frontal area of the truck. with warm regards, JSM |
|
|
||
|
November 26, 2007, 06:11
|
Re: Drag coefficient - frontal area
|
#2 |
|
Guest
Posts: n/a
|
it doesnt matter since the symmetry condition, you can get full view of the truck via DISPLAY/VIEW/MIRROR all the time.
|
|
|
|
||
|
November 27, 2007, 09:13
|
Re: Drag coefficient - frontal area
|
#3 |
|
Guest
Posts: n/a
|
Use the half area!
|
|
|
|
||
|
December 3, 2007, 05:57
|
Re: Drag coefficient - frontal area
|
#4 |
|
Guest
Posts: n/a
|
Hi Louise,
Thanks for your help. Sorry for delayed response. with warm regards, JSM |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drag Coefficient Convergence Problem | John | FLUENT | 18 | June 24, 2023 09:22 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
| Reference Area for Calculating Lift and Drag Coefficient of 3D wing | mahbub03 | Main CFD Forum | 3 | May 19, 2011 00:21 |
| Automotive test case | vinz | OpenFOAM Running, Solving & CFD | 98 | October 27, 2008 08:43 |
| CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
Linear Mode
