|
[Sponsors] |
December 15, 2007, 14:52 |
floating point error
|
#1 |
Guest
Posts: n/a
|
Hello,
I'm running a 2ddp, pbns, eulerian, spe, laminar, unsteady case. If I put a small number of iterations per time step, every thing is ok. However, if I increase the number of iterations (20 for example) I got a message error just after approximately 18iterations : Error: floating point error: overflow Error Object: () Why did this happen for large iteration's number and how can I remedy? Thanks |
|
January 9, 2008, 05:46 |
Re: floating point error
|
#2 |
Guest
Posts: n/a
|
hi,
i oftenly get this msg " error: divide by zero" after finished convergence results when i see the results. wat is the problem? could u tell me where i did mistake? |
|
January 9, 2008, 15:13 |
Re: floating point error
|
#3 |
Guest
Posts: n/a
|
Hi,
Sincerely, I have no idea!! (( I got this error previously. I think it can be related to some strange values encountred while iterating or some errors concerning the values you entered while setting the case. Well, in any case, try to be precise as possible as you can when setting your case! that's all i can tell you! sorry! sometimes errors occur because of very insignificant lack of attention!! good luck |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
c++ libraries and solver compiling | vaina74 | OpenFOAM Installation | 13 | February 3, 2012 17:43 |
Problem with UDF compiling for kTkLW model | Wantami | FLUENT | 0 | July 18, 2011 05:11 |
Accessing phi from a fvPatchField at same patch | johndeas | OpenFOAM | 1 | September 13, 2010 20:23 |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 10:23 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |