Home > Forums > Software User Forums > ANSYS > FLUENT

use of Gturbo to make turbine blade

Mark Forums Read

Reply

Search this Thread

December 31, 2007, 06:47	use of Gturbo to make turbine blade	#1
usman Guest Posts: n/a	Hi, I don't have Gturbo option in my Gambit. I have turbine blade's geometry as radial cuts at three blade heights. Which other software should i use to make a good model. Can i still make it in Gambit. Kindly guide me step by step method to make 3D turbine blade, volume, meshing etc. Any help would be highly appreciated. Many Thanks,

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mesh a twisted wind turbine blade	Laurenjiongo	Main CFD Forum	6	January 29, 2018 07:13
[Other] ANSYS CFX-Meshing problem of a wind turbine blade	Zoe	ANSYS Meshing & Geometry	1	July 14, 2010 03:02
Installation OF1.5-dev	ttdtud	OpenFOAM Installation	46	May 5, 2009 03:32
Regarding FoamX running Kindly help out	hariya03	OpenFOAM Pre-Processing	0	April 18, 2008 05:26
Turbine blade section co-ordinates	Iason Hatzitheodorou	FLUENT	1	September 26, 2004 23:33

All times are GMT -4. The time now is 05:31.