Home > Forums > Software User Forums > ANSYS > FLUENT

Reducing residuals with PDF combustion model

Mark Forums Read

Reply

Search this Thread

January 7, 2008, 09:06	Reducing residuals with PDF combustion model	#1
Don Guest Posts: n/a	I am currently running several simulations using the PDF transport combustion model for turbulent fully premixed combustion. The residuals have leveled off at values that are higher than I would ideally like (continuity is 1E-2). The fluent manual suggests increasing the time averages increment in the iterations panel, I have done this but with no success. I was hoping someone has had a similar situation and could offer some advice. Thank you all very much for your time and any future advice. - Don

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Combustion mechanism for PDF model	zdz198728	Main CFD Forum	0	October 6, 2009 03:04
Combustion Model for CAI/HCCI - AVL FIRE	Patryk	Main CFD Forum	0	July 24, 2009 16:43
Help about premixed combustion with BVM model	Nena	CFX	1	September 8, 2007 10:15
PDF Transport Model HELP	Don	FLUENT	3	August 22, 2007 15:27
About Composition PDF Transport Model	cfdfans	FLUENT	0	October 25, 2004 06:00

All times are GMT -4. The time now is 04:44.