|
[Sponsors] |
January 15, 2008, 17:49 |
how to connect an edge with a face
|
#1 |
Guest
Posts: n/a
|
hi, how can i connect an edge with a face in Gambit. The edge is just over the face.
Many Thanks, |
|
January 16, 2008, 05:53 |
Re: how to connect an edge with a face
|
#2 |
Guest
Posts: n/a
|
Things are not clear! could you explain a little more of your problem..?
|
|
January 16, 2008, 08:19 |
Re: how to connect an edge with a face
|
#3 |
Guest
Posts: n/a
|
hi, actually i have three cross-sections of a turbine blade (at hub, midspan and tip). I am trying to make blade out of it. i have made the hub and casing. I want to connect hub and casing cross-sections of blades to hub and tip respectively. Unfortunately, i don't have Gturbo software. I am making geometry in Gambit. Many thanks for your help dear friend.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |