|
[Sponsors] |
February 6, 2008, 08:03 |
Residual oscillations - How to stop?
|
#1 |
Guest
Posts: n/a
|
Hello,
I am running simulations for external flow around a vehicle for grids of up to 5 millions cells. All the residuals do converge to a nice flat plateau after 3000 iterations but there are not insignificant oscillations present. I have relaxed the solution but I can seem to dampen them out, any ideas? The worst residual is epsilon for the realizable k-epsilon model and I am worried that my solutions are flawed. Any helps would be greatly appreciated. Carlos. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transsonic nozzle with rhoSimpleFoam | Unseen | OpenFOAM Running, Solving & CFD | 8 | July 1, 2022 06:54 |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |