ISO SURFACE

February 17, 2008, 09:49

Hi, I'm modeling an open channel flow.. I want to track the air water interface.. I 've an ISO SURFACE with 0.5 value, for Volume Fraction Now, when I display it, it doesnt show the air water interface.. any idea where i'm getting wrong.. Here is the picture of what I get..

http://cid60157d8f9414c461.skydrive....lf.aspx/Fluent%20Project-/iso-surface.JPG

Thanks in advance

February 17, 2008, 09:51

Please copy paste the link in new window if you fail to see the image http://cid-60157d8f9414c461.skydrive...lf.aspx/Fluent%20Project-/iso-surface.JPG

February 17, 2008, 09:49	ISO SURFACE	#1
Umm.. Guest Posts: n/a	Hi, I'm modeling an open channel flow.. I want to track the air water interface.. I 've an ISO SURFACE with 0.5 value, for Volume Fraction Now, when I display it, it doesnt show the air water interface.. any idea where i'm getting wrong.. Here is the picture of what I get.. http://cid60157d8f9414c461.skydrive....lf.aspx/Fluent%20Project-/iso-surface.JPG Thanks in advance

February 17, 2008, 09:51	Re: ISO SURFACE	#2
Umm.. Guest Posts: n/a	Please copy paste the link in new window if you fail to see the image http://cid-60157d8f9414c461.skydrive...lf.aspx/Fluent%20Project-/iso-surface.JPG

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 11:12
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 11:05
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19