|
[Sponsors] |
February 21, 2008, 06:30 |
Boundary condition in pressure equation
|
#1 |
Guest
Posts: n/a
|
Hello, i have a doubt the boundary condition that Fluent uses for the pressure equation.
In the user's guide, section 25.4.1, Pressure Interpolation Scheme, it's written: "Another source of error is that FLUENT assumes that the normal pressure gradient at the wall is zero..." Is it referred to the use of this particular interpolation scheme or it is the only one boundary condition for the pressure equation? Thanks a lot |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure boundary condition | C-H Kuo | Main CFD Forum | 18 | September 16, 2016 03:19 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Implications for heat transfer when outlet pressure boundary condition used | Blob | CFX | 2 | March 26, 2009 06:22 |
How to give pressure boundary condition in SIMPLER algorithm | shyamprasad | Main CFD Forum | 0 | March 16, 2009 23:40 |