CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Meshing problem

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   April 4, 2008, 16:13
Default Meshing problem
  #1
Sanjay Jain
Guest
 
Posts: n/a
Dear Sir, When I was meshing runner of Francis turbine (hydro turbine) using Tet/Hybrid-TGrid scheme(volume meshing), GAMBIT shows following message. "Initialization failed, perturb boundary nodes and try again."

What does it mean? and how to solve it?

Is it necessary to mesh first line then face and then finally volume?

Waiting for valuable reply.

With regards

Sanjay Jain
  Reply With Quote

Old   April 7, 2008, 03:05
Default Re: Meshing problem
  #2
mAx
Guest
 
Posts: n/a
Check your geometry: If you have small edges, small angles between edges, etc... Gambit will return you this kind of message. You should clean up your geometry.
  Reply With Quote

Old   April 7, 2008, 11:37
Default Re: Meshing problem
  #3
Sanjay Jain
Guest
 
Posts: n/a
Thanks for your suggestions. I will try.

  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Meshing problem Tomas FLUENT 0 July 1, 2008 10:31
Meshing problem Sanjay Jain FLUENT 6 April 5, 2008 10:51
Meshing problem akr FLUENT 2 February 3, 2008 21:22
meshing problem danard CFX 3 March 2, 2003 20:17
Meshing problem John FLUENT 2 January 31, 2003 13:08


All times are GMT -4. The time now is 00:09.