 |
 |
 |
|
|
|
[Sponsors] | ||||
April 19, 2008, 19:26
|
Animation problem
|
#1 |
|
Guest
Posts: n/a
|
Hello!
I'm modelling a transient two-phase flow in 2D and need to create an animation of the flow. Now the problem is the pipe is too long 15m,and diameter just 0.1. when I create a animation, whole pipe was shown, it looks pipe is too thin to see the detail inside. So I want to animate just part of pipe ,maybe just 2 meter (from 9 to 11 meter). Then I can see how fluid flow. How should I do? Thank you in advance. |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with animation monitor | Julian K. | FLUENT | 0 | February 10, 2009 06:06 |
| animation for steady problem | teresa | CFX | 2 | August 29, 2008 02:30 |
| Animation Problem | Salehi | FLUENT | 5 | June 2, 2007 05:30 |
| Animation problem | ap | FLUENT | 4 | December 7, 2004 17:44 |
| problem with Animation | Deepak Tiwari | FLUENT | 0 | August 19, 2002 05:49 |
Linear Mode
