Home > Forums > Software User Forums > ANSYS > FLUENT

Turbine spiral case postprocessing

Mark Forums Read

Reply

Search this Thread

April 24, 2008, 03:24	Turbine spiral case postprocessing	#1
mateus Guest Posts: n/a	Hi, I'm simulating a turbine spiral case,stay and guide vanes. There was no problem with simulation but I have an issue with postprocessing. To evaluate the design I need to determine the flow rate through individual guide vane passage. Is there any way to do this in Fluent. I guess I need to make isosurfaces at constant radial dimension that would be bound to individual blade passage and then calculate the flow rate... Any ideas? Mateus

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM] Postprocessing a billion cell CFD case	hjasak	ParaView	8	May 28, 2009 14:02
geometrie spiral	Nicolás	FLUENT	0	December 8, 2007 04:08
GAMM Francis Turbine Case 8	mukkarum	Main CFD Forum	0	July 12, 2003 00:30
Spiral Jet Mill	Kargl Karl	Main CFD Forum	0	June 28, 2000 04:37
Vortex vs Spiral	Ashok grover	Main CFD Forum	1	November 28, 1999 12:16

All times are GMT -4. The time now is 02:52.