|
[Sponsors] |
May 12, 2008, 18:28 |
Variables at the Internal Face
|
#1 |
Guest
Posts: n/a
|
Hy every one I set some planes in a 3D simulation as Interior and I would like to have the velocity profile at those planes... via UDF...
As I can see I only have access to the F_FLUX and F_P and F_FLUX give me the mass flow rate through a given face in a face thread. So how can I get the U,V and W velocities at some face? Does someone know it?? Thanks Lourival |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic | sponiar | OpenFOAM Meshing & Mesh Conversion | 2 | March 30, 2009 15:02 |
how to get fluid internal internal energy | vbk | FLUENT | 0 | December 17, 2007 01:54 |
GAMBIT internal error:face not found in the stack | Jean-Baptiste | FLUENT | 0 | October 16, 2007 09:02 |
can't access face variables ... | bart weisser | FLUENT | 2 | September 28, 2007 14:09 |
Interior/internal face | Mattis Voss | FLUENT | 3 | November 10, 2005 15:53 |