|May 18, 2008, 12:32||
Input boundary condition is getting manipulated
Hi all, I am simulating flow in a 3D duct with heat transfer. I have used velocity inlet as inlet boundary condition, pressure outlet as outlet boundary condition and other faces with wall with some of them having heat flux input. My solution is getting converged.
But the problem is my inlet boundary condition (temperature) is getting manipulated of its own and outlet temperature is very low. I am not understanding why my inlet boundary condition is getting manipulated. Any solution from anyone?
Thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|input to boundary condition||NVSD BABU||CFX||2||January 4, 2009 14:07|
|Mapping manipulated pressures back into CFX Post||Molly||CFX||0||August 27, 2008 07:52|
|doubt on scalar input in pressure boundary||pathak||CD-adapco||3||September 28, 2007 03:20|
|Boundary condition of the third kind or Danckwertz boundary condition||plage||OpenFOAM Running, Solving & CFD||4||October 3, 2006 12:21|
|Request to help with input boundary condition||Arif||FLUENT||2||April 11, 2006 05:38|