|
[Sponsors] |
Would you mind tell me how to genetethe mesh size |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 8, 2008, 06:32 |
Would you mind tell me how to genetethe mesh size
|
#1 |
Guest
Posts: n/a
|
Hi,everybody! Thank you very much for your attention! I am ready to generate a 3D mesh of of cylindrical vessel.
I study a water jet plunging into this vessel. I would like to generate smaller meshs just near the impinging zone in the same volume (vessel volum ) but I did not know how to proceed. thank you much in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[mesh manipulation] Making a mesh with different regions mesh size | mou_mi | OpenFOAM Meshing & Mesh Conversion | 7 | June 17, 2008 17:26 |
Would you mind tell me how to create the 3D mesh? | yuanye | FLUENT | 0 | June 8, 2008 03:55 |
Never mind.... | Steve Roberts | CFX | 0 | May 5, 2006 10:44 |
simulation or modeling of mans mind | han | Main CFD Forum | 7 | December 14, 2005 15:17 |
Mind Reader-What's the trick? | Selina Tracy | Main CFD Forum | 5 | April 24, 2003 12:18 |