|
[Sponsors] |
July 21, 2010, 13:17 |
Surface points
|
#1 |
New Member
Yarzar
Join Date: May 2010
Posts: 22
Rep Power: 15 |
Hi,
I can't create any surface points in my domain. I tried everywhere and it won't work. What should I do ?? Plz help. Thanks !! |
|
July 21, 2010, 14:22 |
|
#3 |
New Member
Yarzar
Join Date: May 2010
Posts: 22
Rep Power: 15 |
That was the problem of inputting them with less time.
Now, I could input them easily but fluent won't accept the points. It says "surface creation failed ocject #F" For one case, only a few poitns were refused but for another one, fluent won't accept any of the points. The coordinates are right because they worked fine in Workbench. Any suggestions ?? |
|
July 21, 2010, 15:04 |
|
#4 |
Senior Member
Chris
Join Date: Jul 2009
Location: Ohio, USA
Posts: 169
Rep Power: 16 |
It seems like this error occurs when you attempt to create a point that is outside of the solution domain. Have you made sure that the units of coordinates of the point match those of the solution?
|
|
July 23, 2010, 15:48 |
|
#5 |
New Member
Yarzar
Join Date: May 2010
Posts: 22
Rep Power: 15 |
Thanks !
it seems like I had several problems. First, my units were in mm and FLuent was set in m. Another thing was that I had to shift the points about 0.1mm from the actual place to not interfere with the boundary... Thnaks again :-) |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |