|
[Sponsors] |
July 21, 2008, 02:40 |
CREATION OF BOUNDARY LAYER
|
#1 |
Guest
Posts: n/a
|
Hi. i have a question regarding the creation of a boundary layer around the 2d cylinder. when i create the boundary layer it becomes pointed near the rear stagnation point. i want to create a dense boundary layer so i have kept the following parameters in GAMBIT: first row=0.00003 growth factor=1.15 rows=20 when i increase the rows boundary layer becomes more distorted. i would really appreciate if someone can help meto create aperfect boundary layer. thanks
|
|
July 24, 2008, 05:08 |
Re: CREATION OF BOUNDARY LAYER
|
#2 |
Guest
Posts: n/a
|
Hi,
did u use uniform or aspect ratio based Boun.. layer.. if u use unoform u won t get any distortions. |
|
July 31, 2008, 14:41 |
Re: CREATION OF BOUNDARY LAYER
|
#3 |
Guest
Posts: n/a
|
actually i have tried both but no success
|
|
August 1, 2008, 01:33 |
Re: CREATION OF BOUNDARY LAYER
|
#4 |
Guest
Posts: n/a
|
hi,
then try to reduce the first cell height i.e. instead of first row=0.00003... increase its value... may be 0.0003 for any problem this fine ness is more than sufficient. ok try this,. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boundary conditions for turbulent boundary layer | Thomas | FLUENT | 1 | June 17, 2008 06:14 |
boundary conditions for boundary layer flow | A. Al-zoubi | CFX | 0 | November 3, 2007 08:11 |
Boundary Layer | Emiliano | FLUENT | 0 | September 26, 2007 06:01 |
Boundary layer | Glenn | FLUENT | 1 | August 14, 2002 00:55 |
Boundary layer | Park Geun Hong | FLUENT | 1 | February 24, 2000 15:13 |