 |
 |
 |
|
|
|
[Sponsors] | ||||
July 21, 2008, 15:28
|
MRF & Multiphase
|
#1 |
|
Guest
Posts: n/a
|
Hello,
I would to model water at the tip of a moving syringe (not just the plunger, but the entire cylinder) -- I start with a stationary syringe and move only the plunger using a UDF till desired amount of fluid comes out of the tip (Using VOF multiphase model). At this stage I would like to move the whole system at a certain velocity. Any suggestions what method to use to solve this problem would be greatly appreciated. Thank you, Neil |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multiphase UDS | new_to_udf's | FLUENT | 1 | October 27, 2009 05:15 |
| multiphase | greg | FLUENT | 3 | July 4, 2006 10:24 |
| about multiphase | whpsoft | FLUENT | 3 | October 13, 2004 01:05 |
| multiphase | aris | Main CFD Forum | 2 | June 28, 2004 09:11 |
| Again multiphase! | Albert | Main CFD Forum | 0 | February 17, 2003 17:27 |
Linear Mode
