|
[Sponsors] |
UDF: coupling between measurements and actuation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 31, 2008, 04:31 |
UDF: coupling between measurements and actuation
|
#1 |
Guest
Posts: n/a
|
Hi folks,
I have a question regarding UDFs in Fluent. I want to measure a pressure within a UDF, afterwards inject according this the measured pressure an amount of fuel. Is this principally possible and which macros should I use? For injecting fuel, I guess DEFINE_SOURCE is an promising option. What I have tried: Within the DEFINE_EXECUTE_AT_END the pressure is calculated and afterwards a value for injection is calculated using this pressure. This amount of mass is then injected using the DEFINE_SOURCE. The UDF compiles fine but I am getting the following error message during simulation: "/FLUENT/Fluent.Inc/fluent6.3.26/lnamd64/3d_host/fluent.6.3.26[0xd55e51] /lib64/libpthread.so.0[0x365440de60] libudf/lnamd64/3d_host/libudf.so(execute_at_end+0x1b5)[0x2aaaabb3dffa]" I have no idea what causes this error. Any suggestions? Thanks, Fabian |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transient measurements? | TobiasZ | CFX | 2 | May 11, 2006 10:47 |
Fluid measurements | ramesh | Main CFD Forum | 2 | October 22, 2005 06:02 |
Point measurements | Nick | CFX | 3 | March 7, 2003 13:35 |
2D cavity flow measurements | Ricki | Main CFD Forum | 0 | November 13, 2001 04:31 |
multistage compressor measurements | clifford bradford | Main CFD Forum | 1 | February 8, 2001 18:02 |