Urgent! How to make a line contour and mark number

August 16, 2008, 12:10

Dear Fluent Users,

I want to make a figure of line contour of temperature by Fluent and I wan to mark number on each line. But I can not find any option in Fluent to do so.

Can anyone give me some suggestions on doing this?

Thanks so much in advance,

Best regards,

Thanh

August 19, 2008, 22:54

Hello, Thanh I think you can use TECPLOT(a software for postproceeding) to do this.

Best wishes! Yong

August 20, 2008, 13:25

Hi, Yong, Thanks for your suggestion. But there are some problems when I load fluent data in TECPLOT. It seems that the scale of the 3D Cartesians is not idential. The other problem is that I can not make a contours of a variable at a certain cross section. Can you give me some more suggestion on solving that? Thanks a lot in advance

Thanh

August 16, 2008, 12:10	Urgent! How to make a line contour and mark number	#1
Thanh Guest Posts: n/a	Dear Fluent Users, I want to make a figure of line contour of temperature by Fluent and I wan to mark number on each line. But I can not find any option in Fluent to do so. Can anyone give me some suggestions on doing this? Thanks so much in advance, Best regards, Thanh

August 19, 2008, 22:54	Re: Urgent! How to make a line contour and mark nu	#2
yong Guest Posts: n/a	Hello, Thanh I think you can use TECPLOT(a software for postproceeding) to do this. Best wishes! Yong

August 20, 2008, 13:25	Re: Urgent! How to make a line contour and mark nu	#3
Thanh Guest Posts: n/a	Hi, Yong, Thanks for your suggestion. But there are some problems when I load fluent data in TECPLOT. It seems that the scale of the 3D Cartesians is not idential. The other problem is that I can not make a contours of a variable at a certain cross section. Can you give me some more suggestion on solving that? Thanks a lot in advance Thanh

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to make camber line of airfoil	Usman	FLUENT	0	January 22, 2008 16:13
Line contour plot in black	Radhika	Siemens	3	March 22, 2007 06:44
Line 140 make command not found What is the solution	faroque	OpenFOAM	1	November 13, 2006 04:16
How to change contour line thickness?	Mishar	Siemens	0	December 15, 2004 10:28
Local surface contour line plots	Nandu	FLUENT	0	November 9, 2003 23:26