|
[Sponsors] |
August 24, 2008, 13:21 |
Plate Heat Exchanger internal wall problem?
|
#1 |
Guest
Posts: n/a
|
I am trying to create a plate heat exchanger using Gambit, i set the inflow wall to velocity inlet and the outflow wall to pressure outlet. There is an internal wall that is only connected at one end to allow for the flow but i cant create a face including it? Also in Fluent how do i set the walls to 90 celcius or 293K?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to simulate Plate Heat Exchanger | Summer | FLUENT | 4 | February 17, 2022 02:37 |
Plate heat exchanger | Mohsen Djalali | FLUENT | 2 | May 18, 2011 04:49 |
Plate fin heat exchanger | ajay dehriya | FLUENT | 0 | December 15, 2007 10:12 |
Plate heat exchanger modeling | Ozlem | Phoenics | 14 | December 11, 2007 06:13 |
Heat exchanger problem | icedou | FLUENT | 1 | July 12, 2005 19:10 |