Residuals of continuity not converging2

aja1345 · September 12, 2015, 15:45

Hi,

I'm simulating a turbine.

The convergence of solution is monitored by checking the residuals of the numerically solved governing equations.
The "viscous-spalarat-almaras" model is used, and used air with constant density. Pressure-velocity coupled scheme and pressure based solver are selected.
According to the following figures, torque is increasing but the residual of continuity does not decrease and is almost constant. This turbine have a Tip-Gap(tip clearance) region. This region is small and In other words, air flow pass this region.

Is there any problem?

According to monitored torque, the solution is not converged.

I am grateful that guide me about this case.

Thanks,

Best,

Aja

aja1345 · September 12, 2015, 18:38

Can no-one guide?

aja1345 · September 13, 2015, 02:26

Now I understand that second figure is not torque but it is total torque coefficient. How do I monitor the torque?

September 12, 2015, 15:45	Residuals of continuity not converging2	#1
aja1345 Senior Member Aja Join Date: Nov 2013 Posts: 496 Rep Power: 14	Hi, I'm simulating a turbine. The convergence of solution is monitored by checking the residuals of the numerically solved governing equations. The "viscous-spalarat-almaras" model is used, and used air with constant density. Pressure-velocity coupled scheme and pressure based solver are selected. According to the following figures, torque is increasing but the residual of continuity does not decrease and is almost constant. This turbine have a Tip-Gap(tip clearance) region. This region is small and In other words, air flow pass this region. Is there any problem? According to monitored torque, the solution is not converged. I am grateful that guide me about this case. Thanks, Best, Aja Last edited by aja1345; September 16, 2015 at 15:13.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Micro Scale Pore, icoFoam	gooya_kabir	OpenFOAM Running, Solving & CFD	2	November 2, 2013 13:58
How to write k and epsilon before the abnormal end	xiuying	OpenFOAM Running, Solving & CFD	8	August 27, 2013 15:33
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3	bookie56	OpenFOAM Installation	8	August 13, 2011 04:03
IcoFoam parallel woes	msrinath80	OpenFOAM Running, Solving & CFD	9	July 22, 2007 02:58
Could anybody help me see this error and give help	liugx212	OpenFOAM Running, Solving & CFD	3	January 4, 2006 18:07

September 12, 2015, 18:38		#2
aja1345 Senior Member Aja Join Date: Nov 2013 Posts: 496 Rep Power: 14	Can no-one guide?

September 13, 2015, 02:26		#3
aja1345 Senior Member Aja Join Date: Nov 2013 Posts: 496 Rep Power: 14	Now I understand that second figure is not torque but it is total torque coefficient. How do I monitor the torque?