|
[Sponsors] |
September 28, 2008, 12:18 |
Is it possible to combine results?
|
#1 |
Guest
Posts: n/a
|
Hi,
I'm trying to run a 3D simulation on Ahmed Body. However, my computer can't run on cells higher than 2 millions. I'm planning to mesh around 3 million or higher number of cells and divide the mesh into halve. Is it possible that I run the first half of my mesh in fluent and the other half later and combine both results? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
combine meshes in gambit | Mak | FLUENT | 2 | October 7, 2008 12:25 |
how to combine two flow | jai | FLUENT | 0 | March 22, 2008 03:02 |
how to combine thermal and structural | venkatesh r | CFX | 1 | April 10, 2007 06:31 |
[mesh manipulation] How to combine two meshes | hsieh | OpenFOAM Meshing & Mesh Conversion | 1 | March 16, 2006 10:43 |
DPM and free surface: how to combine? | Easycad | FLUENT | 1 | November 2, 2003 14:17 |