|
[Sponsors] |
October 6, 2008, 14:03 |
Tolerance in GAMBIT Help!!!!!!
|
#1 |
Guest
Posts: n/a
|
Please, i need help!!! After the whole day fighting with Gambit, i could split one volume with a face i created. The problem is that this face i created had a tolerance close to 0.18. So to split it i had to change manually the tolerance level to 0.19. Is it important??
what is the meaning of this tolerance? will it affect the mesh or later in fluent?? Thanks in advance! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh quality tolerance | nick | CFX | 3 | March 26, 2008 16:28 |
SlidingInterface Tolerance | graser | OpenFOAM Running, Solving & CFD | 2 | November 27, 2007 06:53 |
Tri Tolerance in ICEM Hexa | Mohammad Faridul Alam | CFX | 1 | November 21, 2007 10:55 |
GAMBIT - warn about geometric tolerance | CFDNewbie | FLUENT | 2 | July 7, 2007 09:48 |
Global Modeling Tolerance | Neser | CFX | 1 | December 23, 2004 16:18 |