Hallo,

after importing a part from Solidworks by the .STEP format, I performed a Face Check on all faces:

Cmd> face check topology geometry

GAMBIT's answer was the following:

ERROR: ACIS error 4208 : surface is not G1 EROOR: Problematic geometry reported for the face face.128

I searched the web for a similar error message, but couldn't find anything.

My question is: What does this error message mean? What can I do to repair the face face.128?

Thanks,

Julian

try to delete the volume without lower topology (eg: faces), and then delete face.128. Rebuild face.128, with wireframe (from edges) and rebuild the volume with wirefram (from faces) it could work