|
[Sponsors] |
November 22, 2008, 12:01 |
Locating points in a display
|
#1 |
Guest
Posts: n/a
|
Dear All,
Suppose there is a single phase liquid flow through a tube under a set of boundary conditions. Now, after the solution is allowed to converge, I wish to simulate a solid particle in the domain. Can that be done by altering the flow properties at a given location ( say by increasing the viscosity to a high value at that particular location, through UDF). I do not wish to use DPM for simulating solid particles. Thanking you in anticipation, Nikhil |
|
November 22, 2008, 12:25 |
Re: Locating points in a display
|
#2 |
Guest
Posts: n/a
|
Many apologies for the incorrect subject line. I have reposted the query under the appropriate subject.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
contour display, some black points | frank | FLUENT | 3 | December 15, 2020 12:25 |
[Technical] Points | Satish Undapalli (Satish) | OpenFOAM Meshing & Mesh Conversion | 7 | May 8, 2008 15:19 |
Locating particles in airblast atomization (DPM) | Prasad Dudhgaonkar | FLUENT | 1 | May 31, 2004 21:43 |
VOF-locating the surface?? | Kristine | FLUENT | 2 | November 11, 2003 10:02 |
Maximum value at different points | zahid | FLUENT | 0 | March 16, 2002 08:13 |