Home > Forums > Software User Forums > ANSYS > FLUENT

Change Units System in Gambit (microfluidic)

Mark Forums Read

Reply

Search this Thread

December 13, 2008, 10:53	Change Units System in Gambit (microfluidic)	#1
djalil Guest Posts: n/a	Hi; I'm currently triying to mesh some microfluidic channels but i get many meshing problems with Gambit, like negative volumes or geometry tolerances. I would like to change the unit system in Gambit, so that it may help using no too small values. Does anyone already faced this kind of problems? thx a lot!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
changing units in gambit	Brendan	FLUENT	2	August 13, 2012 09:12
change coordinate system	Nabil	FLUENT	2	February 12, 2010 11:23
change cartisian system to cylinderical	negar	Main CFD Forum	0	September 2, 2008 09:51
Units GAMBIT	VIRGINIE	FLUENT	2	November 10, 2005 17:37
Change system of units?	Joern	FLUENT	1	February 9, 2004 11:13

All times are GMT -4. The time now is 09:24.