CFD Online Logo CFD Online URL
Home > Forums > FLUENT

Non-Conformal mesh Problem

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   December 23, 2008, 09:51
Default Non-Conformal mesh Problem
Posts: n/a
Hi all, I am trying to mesh a ractangle chamber (2-D geometry). Let's say there is ONE Ractangular chamber, divided by a COMMON EDGE into TWO equal small chamber (say A & B) Now my question is "How shall I divide that geometry by a COMMON EGDE to convert it into sectional (A & B)"(either by SPLIT or SUBSTRACT) so that I can do NON-CONFORMAL meshing on left side portion & right side portion?

What BC I must give at this common EDGE to run the analysis in Fluent

Thanks in Advance. Regards devesh
  Reply With Quote

Old   December 25, 2008, 04:59
Default Re: Non-Conformal mesh Problem
Svetlin Philipov
Posts: n/a Send a scheme of the problem and explanation
  Reply With Quote

Old   December 30, 2008, 13:45
Default Re: Non-Conformal mesh Problem
Posts: n/a
split the face by edge method with connectivity toggled off...
  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
conformal vs. non conformal mesh otho Main CFD Forum 2 May 30, 2008 11:11
non conformal mesh venkatesh FLUENT 0 September 12, 2005 17:08
non-conformal mesh modrio FLUENT 1 July 15, 2005 06:55
Non-conformal mesh question Jason FLUENT 1 January 12, 2005 17:17
Non-conformal mesh Christian FLUENT 5 February 25, 2002 03:32

All times are GMT -4. The time now is 14:35.