|
[Sponsors] |
December 29, 2008, 00:44 |
meshing in gambit
|
#1 |
Guest
Posts: n/a
|
hi all..
i have a problem in meshing the surface with quad mapping scheme. whenever i try this to do i got a error message "surface can't be converted to sub mappable region" please help me in this. is their any alternative way to convert non mappable region to the mappable region?????? |
|
December 29, 2008, 23:09 |
Re: meshing in gambit
|
#2 |
Guest
Posts: n/a
|
Hi shubham, which kind of section/face you want to mesh. As I understand if there is non-uniformity in cross section where projection of nodes are not possible, Gambit does't allow you to do meshing with sub-mappable scheme.
|
|
December 30, 2008, 12:38 |
Re: meshing in gambit
|
#3 |
Guest
Posts: n/a
|
put equal number of nodes in the parallel edges..that too even number of nodes....it should work.
rgds, jagan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
need help on meshing in gambit | renju | FLUENT | 0 | June 25, 2008 09:25 |
need help on meshing in Gambit | Mohsen khalafi | FLUENT | 6 | June 23, 2008 06:09 |
Gambit meshing | Cary | FLUENT | 2 | July 12, 2006 12:00 |
Gambit meshing | bogdan | FLUENT | 1 | August 30, 2005 08:05 |
Gambit Meshing | Alice | FLUENT | 1 | April 19, 2003 02:28 |