Am doing 2 stage turbine analysis (cascade and 3d tubine In cascade analysis i am following Sliding mesh tutorial. As per tutorial it is necessary to set "smaller" ineterface edge as "INTERFACE 1"..& ..larger edge as "INTERFACE 2". But i am not getting a valid result.
i changed mesh size to equal for small and big egdes . Still invalid result.
same is the case for CFX.
PLEASE HELP ME
Re: PERIODIC,INTERFACE PROBLEM
sliding mesh is difficult .. i change to mixing plane approch... it works well but for unsteady behaviour sliding mesh is suitable..
|All times are GMT -4. The time now is 09:12.|