 |
 |
 |
|
|
|
[Sponsors] | ||||
December 26, 2008, 12:29
|
CFD of Aircraft Wing
|
#1 |
|
Guest
Posts: n/a
|
Hi,
I have done the analysis of a 3D wing geometry in fluent. I need to see the downwash created by the air flow. can someone pls tell me how i can see this? also is it possible to see a video of the flow over the entire wing? Thanks! |
|
|
||
|
December 30, 2008, 01:21
|
Re: CFD of Aircraft Wing
|
#2 |
|
Guest
Posts: n/a
|
I think you're better off not using FLUENT Post-processing capabilities. Try using other programmes such as EnSight. FLUENT post-processing capabilities is not good to say the least.
Hope that helps. |
|
|
|
||
|
December 30, 2008, 03:45
|
Re: CFD of Aircraft Wing
|
#3 |
|
Guest
Posts: n/a
|
i would better suggest to use tecplot 360 for post-procwssing. You can see videos and many other thinks much easier than ensight!
|
|
|
|
||
|
January 3, 2009, 01:38
|
Re: CFD of Aircraft Wing
|
#4 |
|
Guest
Posts: n/a
|
Hi,
sorry for the delay. thanks a lot for the tips on postprocessing! |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for an aircraft wing model........ | mimi | FLUENT | 4 | May 28, 2007 04:36 |
| Looking for a standard aircraft wing model........ | mimi | Main CFD Forum | 3 | May 21, 2007 13:26 |
| Looking for an aircraft wing model in FLUENT | mimi | Main CFD Forum | 0 | May 10, 2007 04:03 |
| Modeling Aircraft-Inlet-Wing interface | Riaan | Main CFD Forum | 0 | August 26, 2005 11:45 |
| Aircraft wing modeling | serhat kilerci | FLUENT | 0 | January 13, 2001 14:51 |
Linear Mode
