PERIODIC,INTERFACE PROBLEM

January 2, 2009, 04:52

Am doing 2 stage turbine analysis (cascade and 3d tubine In cascade analysis i am following Sliding mesh tutorial. As per tutorial it is necessary to set "smaller" ineterface edge as "INTERFACE 1"..& ..larger edge as "INTERFACE 2". But i am not getting a valid result.

i changed mesh size to equal for small and big egdes . Still invalid result.

same is the case for CFX.

PLEASE HELP ME

January 6, 2009, 00:07

sliding mesh is difficult .. i change to mixing plane approch... it works well but for unsteady behaviour sliding mesh is suitable..

January 2, 2009, 04:52	PERIODIC,INTERFACE PROBLEM	#1
REJI Guest Posts: n/a	Am doing 2 stage turbine analysis (cascade and 3d tubine In cascade analysis i am following Sliding mesh tutorial. As per tutorial it is necessary to set "smaller" ineterface edge as "INTERFACE 1"..& ..larger edge as "INTERFACE 2". But i am not getting a valid result. i changed mesh size to equal for small and big egdes . Still invalid result. same is the case for CFX. PLEASE HELP ME

January 6, 2009, 00:07	Re: PERIODIC,INTERFACE PROBLEM	#2
REJI Guest Posts: n/a	sliding mesh is difficult .. i change to mixing plane approch... it works well but for unsteady behaviour sliding mesh is suitable..

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2D periodic problem	Markus	CFX	0	August 4, 2008 14:43
Periodic Interface	Magnoli	CFX	0	November 7, 2007 07:51
Un-even Periodic Interface Problem	Jonathan	FLUENT	2	April 12, 2005 16:47
error in defining periodic sliding mesh interface	Flyeden	FLUENT	1	November 11, 2003 22:33
periodic grid interface	santosh	FLUENT	3	August 30, 2001 10:06