|
[Sponsors] |
February 5, 2009, 14:03 |
atrium modelling
|
#1 |
Guest
Posts: n/a
|
Hi, i am modelling an atrium building. there are two different skylight openings on the atrium. The total volume flow rate is 30 m^3/sn and 56m^3/sn for easch opening. i defined the openings as pressure-outlet. i specified the mass flow rate in kg/sn. because the pressure-inlet alternative doesnot include the mass flow information. but during iterations reversed flow is reported. finally i want to ask how i can define an opening and the flow through that opening.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
S2P Modelling | AMP | FLOW-3D | 5 | February 17, 2009 09:53 |
Modelling a fan | Richard | CFX | 3 | October 10, 2006 09:48 |
Smoke simulation inside an atrium | Amr | FLUENT | 1 | February 24, 2006 18:00 |
CVD / ALD Modelling | Mark | Main CFD Forum | 0 | November 25, 2005 05:17 |
vof modelling | Sumeet | FLUENT | 0 | September 10, 2005 11:08 |