CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Moving Non-Confromal Interface

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   February 27, 2009, 09:42
Default Moving Non-Confromal Interface
  #1
bastian
Guest
 
Posts: n/a
Hello,

I would like to move a body through the domain. The domain is divided into two zones: A boundary layer zone extracted by prism cells and a fluid zone consisting of tetrahedra cells. Both zones are created with tgrid. The surrounding interior wall of the prism boundary layer exists of tri and quad elemets. Consequently, there are interfaces built up between the two zones and connected to the two zones.

If the body starts moving the boundary layer and tits connected interfaces are following the motion by smoothing. However, the interfaces connected to the fluid zone do not move and , finally, negative volumes are the result.

Is there any possibility to tie interfaces or has someone a good idea?

Thanks for reply! Cheers Bastian
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Moving interface between water and air (vortex) Thomas Raes FLUENT 0 November 20, 2008 07:03
UDF for VOF interface moving with velocity V Johann FLUENT 3 June 10, 2006 05:42
moving mesh grid interface Dieter FLUENT 6 March 23, 2006 07:54
Moving interface Unal FLUENT 4 April 16, 2004 11:02
Flux Calculation between moving interface. Apurva Shukla Main CFD Forum 0 August 17, 1999 04:56


All times are GMT -4. The time now is 15:49.