|
[Sponsors] |
October 5, 2016, 07:29 |
contour in fluent
|
#1 |
Member
zxc
Join Date: Mar 2015
Posts: 35
Rep Power: 11 |
hi
how can i display the parameters like the image that is attached? Thanks |
|
October 5, 2016, 09:56 |
|
#2 |
Senior Member
Join Date: Nov 2013
Posts: 1,965
Rep Power: 26 |
Step 1: find a way to mark the vorticity isosurface.
Step 2: plot pressure on the marked cells. I can not tell you in full detail how to do the first step, because I never did this. |
|
October 5, 2016, 15:56 |
|
#3 |
Member
zxc
Join Date: Mar 2015
Posts: 35
Rep Power: 11 |
hi
i am working with fluent and when i do this it will draw the mesh and its not continues like the image!! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
heat transfer with RANS wall function, over a flat plate (validation with fluent) | bruce | OpenFOAM Running, Solving & CFD | 6 | January 20, 2017 06:22 |
save contour plot as a pic from fluent | hillat | FLUENT | 3 | September 11, 2014 03:30 |
Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 02:57 |
residence time contour in Fluent | kk | FLUENT | 0 | May 1, 2007 22:56 |