DPM ABORT
 

Hi,

I am getting the following messages when I display Particle Track------

number tracked = 2102, escaped = 3, aborted = 61105, trapped = 0, evaporated = 0, incomplete = 2099 Parallel particle tracking concurrency: 16%

I get an ABORT messages saying

Can't figure which cell particle is going to -- ABORT

Can anyone share their experience with the same.

Re: DPM ABORT
 

are you getting particle tracks of fuel or not. if yes then dont worry about this message.

Re: DPM ABORT
 

Thanks you for your response.

Yes I am able to display the particle tracks.

My material is an Inert Particle.

I have defined REFLECT for all the walls with coefficient of restitution as 0.3 and there is a rotating domain in my analysis.

Re: DPM ABORT
 

try to track some particules which are abort and see where...it could be due to your mesh at some point of the geometry