|March 17, 2009, 01:57||
hollow fiber membrane CFD
Join Date: Mar 2009
Posts: 3Rep Power: 10
Hi all, I am trying to model a hollow fiber membrane as a pressure jump surface
here is my BCs:
pressure inlet (water) pressure outlet
I set the porous jump permeability as 1.7E-16 m^2 and thickness of 0.278mm .
The inlet pressure is 8.4 psi and outlet pressure is 3.8 psi.
The pressure at the side wall is 0 psi
But the case is always not converge, can anybody help?
|Thread||Thread Starter||Forum||Replies||Last Post|
|meshing a hollow box||waalik||FLUENT||3||September 4, 2008 23:10|
|Continuous Fiber Model||sunyafeng||FLUENT||0||June 6, 2008 09:24|
|Incoherent problem table in hollow-fiber spinning||Gianni||FLUENT||0||April 5, 2008 10:33|
|how to specify axis in hollow geometry||vinayak||FLUENT||4||September 1, 2002 10:46|
|how about the add-on modual "continuous fiber'||cfder||FLUENT||0||May 23, 2002 03:22|