 |
 |
 |
|
|
|
[Sponsors] | ||||
March 18, 2009, 03:48
|
Mach number in a Nozzle
|
#1 |
|
New Member
Phung Anh Duc
Join Date: Mar 2009
Posts: 2
Rep Power: 0  |
Hi all...
I'm trying on learning Fluent to analysis fluids in a nozzle, and I don't know the way to show the Mach Number. If anybody know it, please help me Thanks a lot... Last edited by paduc84; March 18, 2009 at 12:10. Reason: I need the help |
|
|
|
|
|
March 19, 2009, 04:14
|
|
#2 |
|
Senior Member
Max
Join Date: Mar 2009
Posts: 133
Rep Power: 17 |
As soon as you have defined your working fluid as compressible one (ideal gas) Ma-Number gets available in the Contours/Velocity category
cheers |
|
|
|
|
|
|
March 25, 2009, 21:49
|
|
#3 |
|
New Member
Phung Anh Duc
Join Date: Mar 2009
Posts: 2
Rep Power: 0 |
Thanks coglione. I got Much Number from your help. Do you have any experience about ejector. I'm researching in Ejector steam which using the water as the working fluid with primary pressure is 1bar. Can you give me any advise. once again thank you so much...
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Centerline mach number in convergent nozzle | jacob | CFX | 1 | October 5, 2005 18:24 |
| mach number | Akbar | FLUENT | 1 | June 24, 2005 03:08 |
| Laval Nozzle Mach Contours | Sohail Ahmed | Main CFD Forum | 0 | May 19, 2004 05:42 |
| Laval Nozzle Mach Contours | Sohail Ahmed | FLUENT | 0 | May 19, 2004 05:40 |
| Low mach number | kei-tee | Main CFD Forum | 2 | February 19, 2003 03:02 |
Linear Mode
