How to adapt region?

gholamghar · April 5, 2009, 08:48

hello
i want to define air and water as picture below,but when i go to Adapt region in fluent i can just choose 4 points(a rectangular) to adapt my region,so if i want to define water as picture below what should i do,should i use adapt region two times to define water like this?
thanks

zhaopeng · April 5, 2009, 13:09

one time is enough,the vertex of rectangular can be located out of the geometry.

gholamghar · April 5, 2009, 13:33

it means that water would exist out of my boundaries too,does it cause problems to my solve?(in my problem a wave will travel from left to right)

zhaopeng · April 5, 2009, 22:57

You can check the water phase distribution by contours of phases after patch,the water will not exist out of the boundaries.

April 5, 2009, 22:57		#4
zhaopeng Member zhao peng Join Date: Mar 2009 Posts: 41 Rep Power: 17	You can check the water phase distribution by contours of phases after patch,the water will not exist out of the boundaries. amin_gls and sajad.me like this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
different between adapt and mark region?	fadhil majnis	FLUENT	0	November 10, 2008 03:29
Gambit HEX core method gives unwanted 2D region	KK	FLUENT	1	February 4, 2008 09:31
Rotating region of a centr. pump - Counter R wall	Emre	CFX	0	September 20, 2007 09:58
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
[Gmsh] Import gmsh msh to Foam	adorean	OpenFOAM Meshing & Mesh Conversion	24	April 27, 2005 08:19

April 5, 2009, 13:09		#2
zhaopeng Member zhao peng Join Date: Mar 2009 Posts: 41 Rep Power: 17	one time is enough,the vertex of rectangular can be located out of the geometry.

April 5, 2009, 13:33		#3
gholamghar Member Join Date: Mar 2009 Posts: 43 Rep Power: 17	it means that water would exist out of my boundaries too,does it cause problems to my solve?(in my problem a wave will travel from left to right)