How to adapt region?
1 Attachment(s)
hello
i want to define air and water as picture below,but when i go to Adapt region in fluent i can just choose 4 points(a rectangular) to adapt my region,so if i want to define water as picture below what should i do,should i use adapt region two times to define water like this? thanks |
one time is enough,the vertex of rectangular can be located out of the geometry.
|
it means that water would exist out of my boundaries too,does it cause problems to my solve?(in my problem a wave will travel from left to right)
|
You can check the water phase distribution by contours of phases after patch,the water will not exist out of the boundaries.
|
All times are GMT -4. The time now is 07:16. |