|June 10, 2009, 11:56||
Flow, Volume and Pressure Reports in Fluent after batch process
Join Date: Jun 2009
Posts: 3Rep Power: 9
I have set up my cases in such a way that a single case is made to run at five different conditions (differing flow splits). I do this in batch processing through a .jou file that I created.
Now, at the end of this batch process, I want Fluent to generate a .srp file for the flows, pressures and area, for all my zones (not just 1 or 2 zones that I can specify the zone IDs) . I want to incorporate a command to make this happen, in my .jou file itself. How do I make fluent write an srp file that gives me the values for ALL THE ZONES ( I DO NOT want to specify the zone IDs but want to have these values for all the zones.)?
|.srp, batch, fluent, process, reports|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Calculation of the Governing Equations||Mihail||CFX||7||September 7, 2014 06:27|
|air bubble is disappear increasing time using vof||xujjun||CFX||9||June 9, 2009 07:59|
|How Does Fluent Handle Volume Flow in 2D and 3D||Shawn||FLUENT||4||July 16, 2008 14:38|
|Gas pressure question||Dan Moskal||Main CFD Forum||0||October 24, 2002 22:02|
|Terrible Mistake In Fluid Dynamics History||Abhi||Main CFD Forum||12||July 8, 2002 09:11|