|
[Sponsors] |
June 17, 2009, 08:14 |
multiphase modelling, boundary conditions
|
#1 |
New Member
Join Date: Jun 2009
Posts: 1
Rep Power: 0 |
Hi all,
I'm very new in CFD and hope you can help me. I want to modell a simple channel with two phases, water and seeding. At the beginnig of my channel I use an velocity-inlet, at the outlet i use an standard outflow condition. If I make a case-check, there is an error message under the topic boundary conditions, "Change the outlet boundary condition. Outflow boundary condition is not compatible with current multiphase settings." Do you know which boundary condition I can use for this problem? I'm using the mixture multiphase modell. Thanks for your answer. |
|
June 17, 2009, 08:26 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
pressure outlet
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
inlet velocity boundary condition | murali | CFX | 5 | August 3, 2012 09:56 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 7, 2008 00:17 |
Boundary conditions for turbulent boundary layer | Thomas | FLUENT | 1 | June 17, 2008 06:14 |
Pressure boundary conditions | Lionel S. | Main CFD Forum | 1 | August 24, 2007 19:03 |
A problem about setting boundary conditions | lyang | Main CFD Forum | 0 | September 19, 1999 19:29 |