Error in Axi symmetric model.

binubtharayil · August 5, 2009, 10:53

Hi.....

While trying to initiate my axi-symmetric model, I receive an error message like this,

"non-positive volume exists"

When I change the "symmetry" to a "wall" or other type of boundary, the model works.
Can anybody help to sort out.

Any help is appreciated in advance........

Thanks and regards......

krisp · August 5, 2009, 11:31

when you create geometry in gambit make sure the axis of rotation is placed on x coordinate. hopefully it works out.

binubtharayil · August 5, 2009, 16:01

I did as you said and it works.
But there are some other errors coming in.
Trying to figure out.
Thank you krisp..........

August 5, 2009, 10:53	Error in Axi symmetric model.	#1
binubtharayil New Member Binu B Tharayil Join Date: Aug 2009 Posts: 7 Rep Power: 15	Hi..... While trying to initiate my axi-symmetric model, I receive an error message like this, "non-positive volume exists" When I change the "symmetry" to a "wall" or other type of boundary, the model works. Can anybody help to sort out. Any help is appreciated in advance........ Thanks and regards......

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
doubts about axi symmetric moving reference frame and	eers	Main CFD Forum	0	July 9, 2009 15:53
BC's for following axi symmetric geometry..	eers	Main CFD Forum	0	June 29, 2009 12:16
algebraic slip model with stirred suspension?	Manuel Krause	CFX	0	April 15, 2005 09:10
references about the fan/radiator model	Mihai ARGHIR	Main CFD Forum	1	January 8, 2001 15:49
Advanced Turbulence Modeling in Fluent, Realizable k-epsilon Model	Jonas Larsson	FLUENT	5	March 13, 2000 03:27

August 5, 2009, 11:31		#2
krisp New Member krisp Join Date: Aug 2009 Posts: 5 Rep Power: 15	when you create geometry in gambit make sure the axis of rotation is placed on x coordinate. hopefully it works out.

August 5, 2009, 16:01		#3
binubtharayil New Member Binu B Tharayil Join Date: Aug 2009 Posts: 7 Rep Power: 15	I did as you said and it works. But there are some other errors coming in. Trying to figure out. Thank you krisp..........