Simulating a duct -- CFD Online Discussion Forums

August 27, 2009, 10:50	Simulating a duct	#1
nanomagic New Member David Garcia Join Date: Aug 2009 Posts: 1 Rep Power: 0	Hello! I am simulating a Formula car in Fluent 6.3 and i have problems with the sidepots (ducts). At this moment the inner sidepot geometry isn’t designed and I want to simulate only the external geometry. My problem is that I don’t know how to set that the mass flow in the intake of the duct is equal to the outtake mass flow. If it is possible, I want to know how to put a loss coefficient because of the inner radiator. Thanks!

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fabric Duct Modeling	Dan	FLUENT	0	June 30, 2008 15:00
Total pressure increase in the diverging duct	shiv	Siemens	3	February 1, 2008 03:39
Turbulent flow in a rectangular duct foam vs fluent	atzaru	OpenFOAM Pre-Processing	7	February 13, 2007 14:42
modelling fuel cell duct in fluent	rajesh kumar tippabhotla	FLUENT	2	October 7, 2004 12:04
flow simulation across a small fan	jane luo	Main CFD Forum	15	April 12, 2004 17:49

All times are GMT -4. The time now is 16:34.