conduction between fluid and solid

takin · September 1, 2009, 12:04

I want to simulate a geometry like this:

T_o
---------
solid
--------- <-interface
Fluid
---------
T_i

I have already generated the geometry and mesh for two zones solid and fluid.

I do'nt know what kind of thermal boundary condition should be applied at wall defined as interface.

Manucia · September 1, 2009, 13:14

At the interface you should have two faces, (one and its shadow)
Both must be set as Thermal coupled condition
hope it helps

takin · September 2, 2009, 03:28

Quote:

Originally Posted by Manucia

At the interface you should have two faces, (one and its shadow)
Both must be set as Thermal coupled condition
hope it helps

thank you, but How can I set the"Thermal coupled condition"?

Manucia · September 2, 2009, 11:03

Define/Boundary conditions/open the thermal panel/ under thermal conditions set "coupled"

September 1, 2009, 12:04	conduction between fluid and solid	#1
takin New Member MK Join Date: Aug 2009 Posts: 22 Rep Power: 16	I want to simulate a geometry like this: T_o --------- solid --------- <-interface Fluid --------- T_i I have already generated the geometry and mesh for two zones solid and fluid. I do'nt know what kind of thermal boundary condition should be applied at wall defined as interface.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How To Convert Fluid wall in Solid Wall Boundary Condition	RGN	FLUENT	4	March 31, 2009 04:43
Fluid - Solid Domain Interface	Daniel	CFX	6	February 15, 2009 18:09
coupling solid and fluid cells??	kcg	Siemens	4	March 13, 2007 09:39
Modeling of solid domains in fluent, no fluid flow	Satish Perivilli	FLUENT	2	December 1, 2005 11:41
Heat conduction through solid rib in periodic duct	Dieter Fauconnier	FLUENT	0	October 7, 2004 08:22

September 1, 2009, 13:14		#2
Manucia New Member Silvia Join Date: Aug 2009 Posts: 3 Rep Power: 16	At the interface you should have two faces, (one and its shadow) Both must be set as Thermal coupled condition hope it helps

September 2, 2009, 11:03		#4
Manucia New Member Silvia Join Date: Aug 2009 Posts: 3 Rep Power: 16	Define/Boundary conditions/open the thermal panel/ under thermal conditions set "coupled"